office chair pedal mount Desk chair mount – Coffeeracers

office chair pedal mount Desk chair mount – CoffeeracersUnfold the CoffeeRacer, roll your desk chair towards it, lock the tilt of your chair and lower your chair onto the CoffeeRacer and you're off! effectively your chair and the CoffeeRacer have become one! no more movement, no more swivel! You now have a no compromise Sim racing setup! Dismounting from the CoffeeRacer, simply tilt back the chair using the tilt function. And slide the chair mount under your chair and no one will notice the semi

Unfold the CoffeeRacer, roll your desk chair towards it, lock the tilt of your chair and lower your chair onto the CoffeeRacer… and you're off!

effectively your chair and the CoffeeRacer have become one! no more movement, no more swivel! You now have a no-compromise Sim racing setup!

Dismounting from the CoffeeRacer, simply tilt back the chair using the tilt function. And slide the chair mount under your chair and no one will notice the semi professional simrig in your room!

this combination truely supports proffessional sim racing equipment, including load-cell braking systems. It has all the advantages of a permanent setup, without being a permanent eyesore and room hogger (to anyone but you obviously).

the desk chair mount has been tested on the ADAC sim expo (conbined with a coffeeracer play, a secretlab titan 2022, simucube sport 2 and heusinkveld sprint pedals) by proffessional simracers, streamers, wheel/pedal manufacturers and gear reviewers and they were all really exited about the stability, the comfortability and the driving experience.

The desk chair connector is designed for gaming chairs with a hole pattern of 20 x 19,50 cm underneath the seat. This includes common chairs such as the Secretlab and Noble chairs. Anything close to this pattern might also work if you posess some DIY skills, Unfortunately, the bottom Herman Miller & Recaro chairs are quite specific so at this point CoffeeRacer has no solution for these chairs.

The desk chair mount works on both the CoffeeRacer 'Play' and the CoffeeRacer 'Go'. With the CoffeeRacer 'Play' you simply put the weight of the chair onto the CoffeeRacer and you are connected. With the CoffeeRacer 'Go' you need to replace the feet for the optional wheels to get the right seating position. A large bolt is provided to connect the desk chair mount with the CoffeeRacer as well. In 99% of the seating positions you do not need to use this, your weight will hold it all together.

Materials: 3mm steel

Powdercoating: black metallic, fine textured